Clearcut Compound Tired of spending countless hours cutting out severe paint defects? Who isn’t? Over the past few years, CARPRO has worked to create a fast and powerful cutting compound that is significantly more aggressive than any other compound CARPRO has produced before!

The result is… CARPRO Clearcut! CARPRO Clearcut is the compound you use BEFORE finishing polish, such as Reflect!

The CARPRO Clearcut was designed to remove defects FAST while allowing you to easily see your work through the polishing compound. After 1-2 passes you can start to watch the defects literally disappear before your eyes as the compound begins to become transparent. This allows you to continue cutting as needed or stop once the defects have been removed and you are ready for a final polish.

In some cases and with the right combinations, this incredible next-generation compound can also be used as a 1-step product! CARPRO Clearcut is an extremely fast-acting liquid abrasive designed from the ground up for efficiency, performance and speed! Unlike other popular compounds on the market, Clearcut does not fool you by swelling paint or hiding water spots and scratches only to reappear later!

Clearcut wipes off completely WITHOUT fillers, and a simple wipe of the eraser EASILY removes any grease. Unlike past pastes, CARPRO Clearcut has its own application method for optimal results… as opposed to the traditional method of going from hard to light, we start with lighter pressure and finish with hard! Also, I find myself using a little more paste with Clearcut than with traditional pastes.

While the Clearcut cuts like a Ginsu, it also produces little dust and wipes up easily! Say goodbye to hours of wasted time and hello to efficiency and lower labor costs!

Features: Latest generation paste. Cuts FAST! Saves time.

No fillers. Low dust. Removes p1200 grit and above.

Safe to use in the body shop. Compatible with both dual action and rotary machines. Compatible with a variety of foam, microfiber and wool pads.

Directions: Prime (clean, dry pad) with a very thin layer of the massaged paste and add another 3-4 pea-sized drops of product. Spread the product over the entire section. Increase speed to HIGH with LOW pressure.

Use MINIMUM pressure for the first 2-3 times, increasing the pressure each time. Increase the pressure with each pass, finishing with heavier pressure. Once the scratches are gone or the polish is fully set, wipe it off with a microfiber towel.

Clean the pad. Go to next section -> Apply 6-8 pea-sized drops to the pad and repeat steps 2-7.